[Dome Glass] Samsung Galaxy S23 Plus Tempered Glass Screen Protector with Installation Kit - Liquid Dispersion Tech
[ATTENTION!] Whitestone Dome Glass Screen Protector for Galaxy S23 Plus is Only designed for Galaxy S23 Plus 2023 Release.
[THE ORIGINAL, LOCA TECHNOLOGY] Dome Glass, which uses an exclusive and original liquid dispersion technology that no one can follow, adheres closely to your Galaxy S23 Plus screen so much that you will think that your phone is without a screen protector attached. Our patented liquid glass evenly disperses over your entire screen, including existing minor scratches or cracks, and hardens to create an impenetrable edge to edge barrier while repairing former cracks and imperfections.
[MAXIMUM PROTECTION] Your S23 Plus will be free from shocks, drops and scratches. Because the hard premium Dome Glass will protect the screen to the maximum by adhering to the screen with liquid adhesive. Dome Glass provides all-round protection to the edge. Also, it is made from superior 9H high quality tempered glass that is scratch resistant and shatterproof to protect your device.
[SUPER SENSITIVE TOUCH] Dome Glass adheres incomparably thinly through liquid adhesive and supports surprisingly sensitive touch response as if it were in a raw state. Ultrasonic recognition is performed immediately without any delay at the moment of touch.
[BUBBLE-FREE INSTALLATION] Be sure to watch the video and attach it easily, but get the best quality result. To prevent errors and air bubbles, our installation frame JIG and UV curing light are included with purchase.
[DESIGNED, TESTED, AND TRUSTED IN CALIFORNIA] Patented in US, EU, KR, JP, CN, and TW, do not confuse this with imitations and see the authentic LOCA screen protection system for yourself.
[LIMITED LIFETIME WARRANTY] We only provide warranty to supported channels. For more details please check warranty page.
*PLEASE WATCH THE INSTALLATION VIDEO
Before you install
1. Remove any pre-installed screen protectors before installing
2. Remove any registered fingerprints that are on the phone
3. Increase touch sensitivity to max
During the install
1. Please make sure your surface is level
2. Place the speaker masking tape on the speaker area of the phone carefully and properly
3. Gently place the installation guide on the glass
4. Wait for the adhesive to touch the bottom of the guide circle before pulling the pin.
(Do Not let the adhesive spread below the line before pulling the pin)
5. Please wait for the adhesive to spread completely before removing the installation guide
6. 1st Cure: 15 seconds on the bottom then 15 seconds on the top
7. 2nd Cure: 1 min on the bottom then 1 min on the top.
8. Re-Register your Fingerprint. Register the same finger in multiple angles.